Honeywell HDZ30A, Руководство пользователя

Страница: 69 / 114

Operation and Configuration | 69
800-16526 - A - 07/2014
Deleting a Preset Tour
Users can command the HDZ Series Analogue PTZ Dome to delete the selected Preset Tour.
Move the cursor to
DELETE and press the IRIS+ key ( ENTER ) to delete the selected Preset
Tour (see Selecting the Preset Tour Number on page 67 for more information on selecting the
Preset Tour to be deleted).
Exiting the Preset Tour Menu
Select the EXIT item to exit the PRESET TOUR menu and go back to the MAIN PAGE 2 to carry
on setup of the HDZ Series camera.
Setting Up an Autopan Path
An Autopan is the motion of scanning an area horizontally, panning back and forth between a
start and end point so that the Analogue PTZ Dome can monitor a horizontal view. The
parameters are listed in the following sections.
Figure 4-19 Autopan Menu
Selecting an Autopan Line
There are four sets of Autopan lines built in to the HDZ Series Analogue PTZ Dome. Users can
choose an Autopan line to execute by pressing LEFT/RIGHT direction keys or using the joystick
(see
Figure 4-19 ).
Setting the Autopan Start and End Points
Follow the procedure below to set the starting position of the AUTOPAN path:
1. Move the cursor to START POINT and press IRIS+ while PT MOVE is flashing. The item
will automatically change to display TO SAVE .
2. Move the dome to a desired starting position using the PTZ controls and press IRIS+ to
save the position as the starting point. The cursor will automatically move to the END
POINT line. The end point must be set to complete the autopan programming.
3. Move the dome to a desired ending position using the PTZ controls and press IRIS+ to
save the position as the ending point.
AUTOPAN
AUTOPAN LINE 1 →
START POINT PT MOVE ↓
END POINT PT MOVE ↓
DIRECTION RIGHT →
SPEED 01 →
RUN AUTOPAN ENTER ↓
DELETE ENTER ↓
EXIT YES