Honeywell ACUIX, Руководство пользователя

Страница: 97 / 148

ACUIX High Speed Dome User Manual
Document 800-01023 Rev A 97
02/08
Find Home on Startup
Each unit has a factory-set mechanical Home position. The receiver board uses the home
position as a reference point for the pan and tilt positions.
Select 5 in the Pan and Tilt Options menu to
turn Find Home on Startup ON or OFF. If
changing from OFF (default) to ON, a
message displays to confirm your selection.
Select
Y
(yes), when prompted, to turn this
feature On. To leave this feature Off, select
N
(no), when prompted.
An operator can send an ACUIX to its home position from the HEGS5000/5001 controller:
1. Press Run Menu until
Find Home
displays on the LCD screen.
2. Press Enter. The controller sends out the data to send the control camera to its
mechanical home position.
Pan Offset
Select 6 from the Pan and Tilt Options menu
to access the Pan Offset Setup menu.
The Pan Offset feature is useful when a new
ACUIX is installed in a dome and the
programming from the existing ACUIX is
transferred to the new ACUIX using the
upload/download feature (see
Chapter 5,
Operation and Programming with IntelliBus™
Protocol
). The alignment of the new ACUIX
may not be exactly the same as the old
ACUIX, causing the programmed positions
of the Presets to be off. Preset 0 is used to define the location of the pan setting.
1. Select 1 to toggle the Offset ON or OFF. For the ACUIX to adjust the positioning of the
ACUIX to the programmed pan offset, the offset must be set to ON.
2. Once Offset is ON, perform the following steps to set the Pan Offset:
****Extreme Caution****
This will cause the scan to
move immediately on startup!
Are you sure that you
want to do this?
-Y/N-
ESC to Exit
Table 7-5 Find Home Operation
If: Then:
Find Home on Startup is
set to off (default) When an ACUIX receives control data with its
address the first time after power-up, the ACUIX finds
home, and then performs the control command.
Find Home on Startup is
set to on The ACUIX finds home after the initial startup delay of
15 seconds has counted down.
Pan Offset Setup
1 Offset ...............OFF
2 Set Pan Offset
ESC to Exit