Honda HRR216VKA K10, Руководство пользователя

Страница: 21 / 183

2-10
SERVICE INFORMATION HRR216VKA
(K5 ~ K7) THE LAWN MOWER IS DIFFICULT TO ROLL BACKWARDS, BUT DOES STOP
PROPELLING WHEN THE SMART DRIVE IS RELEASED
1. Raise the mower to the highest cutting height
to prevent the rear shield from creating extra
roll-back drag.
2. With the engine off and the Smart Drive
control released, place a commercially
available spring scale on the handlebar.
Slowly and steadily pull the mower
backwards and measure the continuous
roll-back force.
• Continuous roll-back force should be less
than 49 N (11 lb).
• If the roll-back force exceeds 49 N (11 lb),
refer to steps 1 thru 3 on page 2-9 .
.
3. Check the roll-back force once again. If the
force exceeds 49 N (11 lb), continue as
follows:
Remove the rear adjuster arms and clean
and inspect the bushings and axle shaft.
Replace any excessively worn bushings.
Apply Honda Marine extreme pressure
NLGI #2 GC-LB grease or equivalent to the
inside of the bushings.
IMPORTANT:
Only use an extreme pressure NLGI #2
GC-LB wheel bearing grease. Proper
application of the correct grease is critical to
ensure proper operation.
DO NOT USE anti-seize, white lithium,
silicone, WD-40, or any other spray lubricant.
4. Go to the Smart Drive Cable Adjustment
procedure (P. 3-10) .
Slowly pull the mower backwards and
measure the roll-back force. Maximum
continuous force is 49 N (11 lb).
SPRING SCALE,
SAMIN25MRP
(Commercially
available)

Apply extreme
pressure
NLGI #2
GC-LB grease.
26 x 44 mm
WASHER
25 mm
CIRCLIP
ADJUSTER
PLATE
ADJUSTER ARM AND AXLE
Clean and inspect the rear
adjuster bushings and axle.