Holzstar 5902504, Инструкция по эксплуатации

Страница: 7 / 24

Intended Use
DKS 504 Vario | Version 1.03 7
3 Intended Use
The JIG SAW DKS 504 Vario is used to saw edged wood
or wood-like workpieces, plastics and non-ferrous me
-
tals. The scroll saw cuts softwood, plastic and non-fer
-
rous metals. In addition, the machine can be easily used
for separating Plexiglas, fiberglass, foam, rubber, leather
and cork. Round materials may only be cut with suitable
holding devices. Only saw blades suitable for the ma
-
chine may be used. The use of cutting discs of all kinds
is prohibited. It is suitable for private use, not for indu
-
strial use. Proper use also includes compliance with all
information in this manual. Any use beyond the intended
use or otherwise is considered misuse.
For structural and technical changes to the JIG SAW, the
company Stürmer Maschinen GmbH assumes no liabi
-
lity.
Claims of any kind due to damage due to improper use
are excluded.
4 Technical Data
4.1 Table
Duty cycle:
The duty cycle S2 30 min (short-time operation) states
that the engine may be permanently loaded for 30 minu
-
tes. Otherwise he would heat up unacceptably. During
the break, the engine cools down again to its starting
temperature.
Noise and vibration:
The effect of noise can cause hearing loss.
Minimize noise and vibration!
- Use only flawless devices.
- Clean and service the device regularly.
- Adapt the method of operation to the device.
- Do not overload the device.
- If necessary, have the device checked.
- Turn off the power when not in use.
DANGER!
Certain types of wood and wood products produce
harmful dust emissions when processed. Therefore,
use your machine only in a well-ventilated room and
use a suction device.
WARNING!
Danger in case of misuse!
Misuse of the JIG SAW can lead to dangerous situations.
- Only operate the scroll saw in the power range spe
-
cified in the technical data.
- Never bypass or override the safety devices.
- Never work on other materials than specified in the
intended use.
- Only operate the scroll saw in a technically perfect
condition.
- Never work on several workpieces at the same time.
Model DKS 504 Vario
Length 630 mm
Width / Depth 320 mm
Height 380 mm
Weight 12 kg
Supply voltage 230 V
Table length 414 mm
Table width 254 mm
Extraction duct 31 / 35 mm
Saw blade length 133 mm
Stroke speed 550-1600 min‾¹
Max. cutting height at 90° 52 mm
Max. cutting height at +45° 20 mm
Power output 42 W
Power consumption 0,09 kW
Nominal mode drive motor S2 30 minutes
Rotational speed 1650-4800 rpm
Chuck Ø 3,1 mm
Wear ear protection!