Holzstar 5902504, Инструкция по эксплуатации

Страница: 10 / 24

10 DKS 504 Vario | Version 1.03
Installation
Use the following equipment:
- 4 Hexagon bolts M8
- 4 Washers Ø 8 mm
- 8 Hex nuts M8
The following steps will make the machine operational:
Step 1: After unpacking, park the machine at the desired
location.
Fig. 4: Mounting on a workbench
A: Base plate of the saw
B: Foam rubber underlay
C: Workbench
D: Flat gasket
E: Washer
F: Hex nut
G: Locknut
H: Hex screw
Step 2: Screw the base plate of the machine over the ho
-
les with the work surface. Do not over tighten the
screws so that the rubber mat absorbs any vibra
-
tion.
7.3 Selection of the correct saw blade
As a rule, choose narrow blades for complicated curved
cuts and wide blades for straight and large curved cuts.
Circular saw blades wear out and must be replaced re
-
gularly to achieve optimum cutting results. Saw blades
generally become dull after 1/2 to 2 hours, depending on
the type of material and the working speed. The best re
-
sults are achieved with pieces that are less than 25 mm
thick.
If you are cutting workpieces that are thicker than 25
mm, you must insert the blade into the workpiece very
slowly. Be especially careful not to bend or twist the
blade when cutting.
7.4 Inserting Pinless Blades
The adapter allows you to use saw blades with no loca
-
ting pins at both ends.
Step 1: Switch off the machine and disconnect the power
plug from the socket.
Step 2: Adjust the locking screw on the adapter until it
covers approximately half of the hole when vie
-
wed from the top.
Fig. 5: Insert saw blade adapter
Step 3: Slightly loosen the other locking screw to push
an adapter onto each end of the blade.
Step 4: Insert the knife and adapters into the machine
(Fig.6). Now set the knife to the correct length.
Fig. 6: Insert pinless blades
Cut right angle with the pinless saw blade
Cut from the side of the saw as soon as your workpiece
has a length of more than 405 mm. With the blade posi
-
tioned, the table must always be in the 0 ° position.
Remove both setscrews from each blade adapter and in
-
sert them into the opposite holes of the blade adapter
perpendicular to the adjustment pin.
Saw blade