Holzstar 5902504, Инструкция по эксплуатации

Страница: 12 / 24

12 DKS 504 Vario | Version 1.03
Installation
Fig. 11: Loosen the saw blade
Step 4: Press the upper pendulum arm down, then hook
the saw blade to the blade holder.
The blade holder has two notches:
Notch 1: For cutting with the upper saw arm.
Notch 2: To cut at right angles with the Upper saw arm.
Fig. 12: Insert the saw blade
Fig. 13: Insert pinless blade
Step 5: Tighten the saw blade (Fig. 11) and fold down
the saw blade guard.
Change the saw blade
Step 1: Turn off the power and disconnect the power
plug from the power outlet.
Step 2: Remove the table cover (Fig. 10).
Step 3: Fold the saw blade guard up andrelax the saw
blade (Fig.11).
Step 4: Press the upper blade holder down.The saw
blade from the lower blade holderfar away and
upwards.
7.8 Align saw blade and saw table
Step 1: Turn off the power and disconnect the power plug
from the power outlet.
Step 2: Loosen the clamping screw of the workpiece holder
and push the workpiece holder upwards. Then tigh
-
ten the clamping screw.
Fig. 14: Position workpiece hold down
Step 3: Release the table lock knob (Fig.15) and tilt the
table until it is approximately at right angles to
the blade.
Step 4: Place a small angle on the saw table next to the
saw blade and lock the table at 90 ° to the angle.
Fig. 15: Tilt the saw table
Step 5: Retighten the table lock using the handle.
DANGER!
If you are using pen-less blades, hook the blade adap
-
ter into the front of the blade holder (Fig.13).
DANGER!
Always insert the saw blade so that the teeth point in
the direction of the saw table.
DANGER!
To avoid an accident, switch off the machine before
-
hand and disconnect the power plug.