Holzstar 5902504, Инструкция по эксплуатации

Страница: 11 / 24

Installation
DKS 504 Vario | Version 1.03 11
7.5 Clamp the saw blade
Turning the saw blade tension handle (Fig.7) counter
-
clockwise decreases (loosens) the blade tension.
Turning the saw blade tension handle (Fig.7) clockwise
increases (tightens) the blade tension.
Fig. 7: Clamping the saw blade
7.6 Tilt the saw table
Fig. 8: Tilt the saw table
Step 1: Loosen the clamping screw (Fig.8).
Step 2: Tilt the saw table to the left until the pointer indi
-
cates the desired angle on the graduated scale.
The worktable can be tilted from 0 ° to 45 ° to the
left.
7.7 Mount the saw blade guard and workpiece
holder
Fig. 9: Mounting the saw blade protection
Step 1: Insert the workpiece hold-down (9) into the hole
on the boom (19) and fasten with the clamping
screw (11).
Step 2: Slide the saw blade guard (10) onto the work
-
piece hold down (9).
Step 3: Guide the screw through the hole of the work
-
piece holder (9) and the saw blade guard (10)
and screw tight.
Step 4: With the clamping screw (11), the saw blade gu
-
ard can be fixed together with the workpiece hol
-
der at different heights.
Install the saw blade
Step 1: Turn off the power and disconnect the power
plug from the power outlet.
Step 2: Remove the table cover (Fig. 10).
Fig. 10: Open the cover
Step 3: Fold the saw blade guard up and loosen the saw
blade (Fig.11).
NOTE!
Do not overstretch the blade. This will help extend
the life of the saw blade.
NOTE!
If the tension is too low, the blade may bend or
break.
DANGER!
If precision work is required, a trial cut should be
made and the grade adjusted if necessary.
DANGER!
Before any maintenance and conversion work on the
Jig saw, the mains plug must be unplugged.
19
9
11
10