34
34
Section 2 - Stripe Hog Systems
NOTICE:
ALWAYS MAKE SURE TO CHECK THE HOG HEAD FOR
SMOOTH AND PROPER OPERATION BEFORE EACH SHIFT.
DO NOT USE EQUIPMENT THAT HAS NOT BEEN CHECKED
THOROUGHLY.
The spray bar is rotated by a special hydraulic
motor. The center of the rotating shaft is drilled
to allow high pressure water to pass through the
shaft to the spray bar. Spray bar rotation is con-
trolled by the HEAD ROTATION speed dial on the
control panel.
The Hog Head design allows the operator to choose
several different length spray bars for specific
removal widths. The operator can choose spray
bar rotation speeds between 700 and 3000 RPM.
The flexible design of the tubular head plate allows
the operator to configure the blasting head in a
variety of configurations to accommodate different
water blasting operations. It is equipped with four
adjustable heavy duty castor wheels that support
the blasting head and prevent the spray bar and
shroud from touching the road surface. The castor
wheels are attached to heavy duty arms mounted
to the tubular head plate. The arms swivel to allow
the wheel location to be adjusted to avoid hazards
such as rumble strips and reflectors or to accom
-
modate other operating situations. The arms are
secured in position by adjustable friction plates
with a bolt and jam nut locking system. The arms
are adjusted by loosening the jam nut and moving
the arm to the desired position. Then tighten the
jam nut to secure the arm.
The castor wheel mount assemblies are threaded
to provide spray bar/blasting head height adjust
-
ment. Adjustment rods attached to each castor
wheel assembly are used to rotate the threaded
shaft to move the wheels up or down. The rods
are equipped with T-handle pins to hold the cas-
tor wheel adjustment and keep the Hog Head at
the desired height. Hog Head height adjustment
(standoff height) should be checked before each
shift and the wheel castors should be inspected
for damage and excessive wear daily. The castors
and wheels should be greased daily for maximum
life expectancy.
Refer to the Waterblasting Operation and Main-
tenance sections of this manual for additional
Hog Head Caster Wheel Adjustment Rods & T-Handle Pins
information on the operation and maintenance of
the castor wheels and blasting head assemblies.
NOTICE:
F O R M A X I M U M P R O D U C T I O N, S TA N D O F F D I S TA N C E
SHOULD NEVER BE MORE THAN ONE (1) INCH.
Threaded Wheel Mount, Adjustment Rod & T-Handle Pin
Содержание SK5500
