(12) Epoxy in the main servo tray where shown
(15) Screw in the wing bolts half way into the wing bolt mounting block Apply ink
or paint to the heads of the two bolts Next center the wing and set it onto the
bolts This will mark where you need to drill
(13) Test fit the wing bolt mounting block to the inside of the fuselage The blind
nuts should face down
(16) After the epoxy has cured place the wing into the fuselage as shown Put the
front in first aligning the dowel rods in the holes Once in place lower the back
into position
(14) Epoxy the wing bolt mounting block in This is a high stress point and extra
care should be taken to ensure a strong joint
(17) Place the wing mounting brace onto the wing as shown and center the wing
and brace with the fuselage NOTE The two indentations on the brace should
face up PlastiZap it on
-6-
