(18) Drill two 4mm holes 90° from the top wing surface for the wing bolts where
the paint marks are.
(21) Epoxy the aileron servo tray mount into the rear section of the wing servo
mount and then epoxy in the tray.
COCKPIT/CANOPY ASSEMBLY
(19) Assemble the wing bolts as shown (bolt — washer — wing — o-ring) and
temporarily fasten down the wing. Check for good fit and then remove.
(A) Cockpit, . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
(B) Canopy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
(C) Cockpit Mounts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
(D) 3x8mm Self-Tapping Screws . . . . . . . . . . . . . . . . . . . . . . . . . . .4
(20) Trial fit the aileron servo tray mount and tray to the wing. NOTE: The front
edge should be on the wood, therefore, you will have to trim away a little
covering for a good fit.
(1) Epoxy the four cockpit mounts to the fuselage as shown. Be careful when
gluing the rear mounts to only glue them to the wing mounting brace.
-7-
