(7) Next, apply epoxy to the top of the horizontal stabilizer and re-position the fin
between the lines. Make sure that the fin is still 90° to the stabilizer. Do the
next step before the glue sets.
(10) After the glue has completely set, assemble the tail wheel section shown. The
wheel should be straight in line with the strip as should be the tail control arms.
Attach the wheel collar to hold the wheel on.
(8) While the epoxy is still wet. position the plastic stabilizer root cover over the fin.
Double check the positioning of the fin after doing this.
(11) Carefully turn over the airplane and attach the 3mmx12mm self-tapping screws
into the center of the fuselage so that the end of spring steel strip is 2 1/2" from
the end.
(9) When satisfied with the fin positioning, apply Cyanoacrylate glue to the
underside edge of the stabilizer root cover and install in place.
(12) Now take the stabilizer supports and bend the ends as shown above.
-19-
