(3) Now place the main gear (angled side facing back) over the screws and secure
it with two 4mm nylon nuts NOTE tighten the nuts all the way and then
loosen them both one turn This will give the gear the correct shock absorbing
qualities
(6) Place the 3mm screw/washer into the top hole of the wheel pants from the
inside And then attach it to the top hole of the main gear using the 3mm nut
(4) Next take the two wheel pants and drill two holes in each one The first hole
should be at the indent (4mm in diameter) The second should be 3/8 above
the first and smaller (3mm diameter)
(7) Flare open the pants and insert the wheel assembly Install the 4mm nut and
tighten holding the inside nut with needle nose pliers
(5) Arrange the above parts as shown and then assemble together Do this twice
Place screw locking compound on the threads when installing the nuts
(8) Make sure that both wheels rotate freely If they do not trim away the plastic as
needed Or if need be, loosen the nuts unscrew the wheel screw, and
retighten
-9-
