HNC Electric HRS Series, Руководство по эксплуатации

Страница: 27 / 41

- 27 -
5.5 Parameter modification
5.5.1 Modification of function parameter
(1) Operating flow chart
Power ON
→
Power-
on→Press the SET button→Press UP/DOWN button→Press the SET button→Press UP/DOWN button→Press
“YES” button
Enter code options
→Select code function →Determine modified code →Modify the setting range→Save the modified
data (Exit)
5.6 Help information and description
Display Description
AC: XXX
Power voltage
3-digit digital voltmeter for monitoring the voltage of three-phase AC power supply.
400A- -380V
Specification of soft
start
Display the specification of this soft starter is 400A/380V.
H1: Error05
Output phase loss
Display the last fault message Err05 (and so on).
…… .
…….
H9
：
Error00
No faults
Display no fault information.
UEr3.0
Software version No.
Display the version of this software is Ver3.0.
Lxxxx
Times of successful
starts
Where XXXX is the total times of successful starts.
Time-run xx
Starting time
Where XX is the time of last start (whether successful or not).
Note: H1-H2 use recursive method to store 9 newly occurred fault information.
·In the state of non-soft start and soft stop, and not enter the setting state, press[YES] to enter the help menu, and then
press [▲], [▼] button to select the prompt information.
·In the help state, press[YES] or [Stop] to exit the help state.
5.7 Protection function and description
This Soft Starter Series soft start controller has a variety of protection functions. Any failure will lead to shutdown and
display the failure prompt. In use, the protection level and parameters should be set appropriately according to different
situations.
Protection function and other parameter:
YES