4
2.2
Operation keys and their functions
In the case of connecting to WJ200 (Ver.2.0 or above) or NE-S1, key functions are shown in
Tab. 3.
Display mode transitions are described in section 4.1.
Tab. 3
Name and function of operation key
No.
Key Name
Function
1 REMOTE
Remote key can change operation command and frequency
command method to the operator. Press the key more than 2
seconds, can change to the operator, and quit from operator after
press the key more than 2 seconds again.
2 READ
The key is used to transfer inverter parameters to the WOP’s
memory. (Refer to chapter 5 for more details.)
3 WRITE
The key is used to copy the
parameter settings
in WOP to inverter.
(Refer to chapter 5 for more details.)
4 ESC
·Back to above layer.
·Cancel the change of
parameter.
5 SET
·Go ahead to below layer.
·When at edit layer, the change of set will be stored and back to
above layer via pressing the key.
6
(1)
·Cursor will move up, or function code will plus“1”.
·Value will plus “1” when press the key.
7
(2)
·Cursor will move down, or function code will minus“1”.
·Value will minus “1” when press the key.
Chapter 2
Name of parts and functions of WOP
REMOTE OPERATOR
○
○
○
○
○
○
