E23
___________________Chapter 2
Set-up
Set the CAM/OFF/PLAY switch to OFF before inserting or removing the PC card.
* Do not use PC cards other than that specified (MP-HD260).
* Do not attempt to attach an adhesive tag, etc. to the PC card to remove it easily. If the PC card is removed while the
MP-EG10W is operating, it could result in malfunction.
Loading the PC Card
1
Open the lid of the PC card inser-
tion slot.
Loosen the screw and remove the lid.
Screw
Lid
2
Insert the PC card.
With the card surface up, insert the PC card until
it is fixed securely into the slot.
3
Close the lid of the PC card slot.
Attach the lid over the slot and screw up.
(Use fingers to screw up when you close the lid of
the PC card slot.)
Eject lever
Removing the PC card
Set the CAM/OFF/PLAY switch to OFF and loosen
the screw to remove the lid. Lay the MP-EG10W on
its side in a horizontal place and push the eject
lever. The PC card will be removed.
* Be careful not to drop the PC card as this could dam-
age it.
When the eject lever does not move:
See “Troubleshooting Guide” on page 91, or check the following two items:
• If the CAM/OFF/PLAY switch is set to CAM or PLAY, the eject lever will not move. Set this to OFF, power
the MP-EG10W from a charged battery pack or AC outlet, and then push the eject lever.
• If the PC card becomes hot after the MP-EG10W is used for a long time, the eject lever will not work even
if the CAM/OFF/PLAY switch is set to OFF, for safety reasons. In this case, leave the MP-EG10W as it
is for 10-20 minutes to cool the PC card. When the temperature is low enough, the eject lever can be
operated.