Hisense Sero 7 Pro, Руководство пользователя

Страница: 62 / 72

61
Appendix B
Sero 7 is designed and manufactured to comply with the limits for exposure to RF energy set by the
Federal Communications Commission (FCC) of the United State. The exposure standard employs a
unit of measurement known as the specific absorption rate, or SAR. The SAR limit applicable to Sero 7
set by the FCC is 1.6 watts per kilogram (W/kg). Tests for SAR are conducted using standard operating
positions specified by these agencies, with Sero 7 transmitting at its highest certified power level in
all tested frequency bands. Although SAR is determined at the highest certified power level in each
frequency band, the actual SAR level of Sero 7 while in operation can be well below the maximum
value because Sero 7 adjusts its WLAN transmitting power based in part on orientation and proximity
to the wireless network. In general, the closer you are to a WLAN Router, the lower the WLAN
transmitting power level.
Sero 7 has been tested, and meets the FCC RF exposure guidelines for WLAN and Bluetooth operation.
When tested at direct body contact, Sero 7’s maximum SAR value for each frequency band is outlined
below:
FCC SAR
Frequency Band (MHz) FCC 1g SAR Limit (W/kg) Highest Value (W/kg)
Model: M470BSA
2412-2462 1.6 1.059
5180-5240 1.6 0.7987
5260-5320 1.6 0.751
5745-5805 1.6 0.692
Additional Information
For more information from the FCC about exposure to RF energy, see: www.fcc.gov/oet/rfsafety
The FCC and the U.S. Food and Drug Administration (FDA) also maintain a consumer website at www.
fda.gov/Radiation-EmittingProducts/default.htm to address inquiries about the safety of mobile
phones. Check the website periodically for updates.
For information about the scientific research related to RF energy exposure, see the EMF Research
Database maintained by the World Health Organization at: www.who.int/emf
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Model: M470BSA
FCC ID: W9HPADP0001