Hioki MR8880-20, Инструкция по эксплуатации

Страница: 192 / 300

8.3 Calculating after Measurement (Manual Calculation)
182
You can set the calculation and perform the numeric value calculation after mea-
surement. You can perform the calculation for all of the waveform data, or specify
the range for which to perform the calculation (p. 183).
8.3 Calculating after Measurement
(Manual Calculation)
Performing Calculation for All Data
2
3
Set [Numerical Calc.] to [On] .
4
Select the calculation type for each of calculations 1 to 4.
Setting options (
∗
. default setting)
(*1).This cannot be set when [Envelope: On].
5
Select each of the calculation targets for the [Ch] setting items.
Setting options (
∗
. default setting)
6
Select [All] from [Range] .
7
Select [Exec] to execute the
calculation.
The numerical calculation results
appear.
[Highspeed]
Average, P-P, Maximum, Minimum, Time To Max, Time To Min, RMS,
Period, Frequency, Area, X-Y Area, Off
∗
[Realtime]
Average(*1), P-P, Maximum, Minimum, Time To Max, Time To Min,
Off
∗
Calculation item
other than X-Y
area value
CH1, CH2, CH3, CH4, ALL
∗
X-Y area value In the case of calculating the X-Y area, you can set each of the X axis
and Y axis.
X:
CH1
∗
, CH2, CH3, CH4
Y: CH1, CH2, CH3, CH4, ALL
∗
3
4
In the following steps, use the cursor keys in the same way
to configure settings.
5
6
1
Start and finish measuring.
7
This can also be set in the waveform
[Wave+Calc] screen. However, the items
that can be set are limited.
Settable items
Numeric calculation: On/Off, Calculation
range selection: All data/Between A and B,
Execute calculation
(Open/confirm the setting information.)
Select the [Setting] screen.