Hioki 8910, Инструкция по эксплуатации

Страница: 35 / 150

27
3.3 Setting Mode
3.3.4 Selecting the CAN definition data to be output
When the [ ENT ] key is pressed to enter the channel number, the
channel number stops flashing. At the same time, the label name of
CAN definition data starts flashing, indicating that CAN definition data
assigned to the output channel can be changed.
In this condition, pressing the [ SEL ] key changes the indication of the
label name. Hold down the [ SEL ] key until the label name of definition
data to be output is shown.
After selecting the CAN definition data to be output, press the [ ENT ]
key. This enters the setting.
1
Enter the channel number.
(Section 3.3.3, 26p.)
2
Press the [SEL] key, and select a label name.
3
Press the [ENT] key.
• To disable output, use the [
SEL
] key to select [
*** OFF ***
], then press
the [
ENT
] key.
• CAN data conversion and output are stopped for all channels while CAN
definition data is being selected.