Hinowa HS701, Руководство пользователя - Безопасность и обслуживание машины

Страница: 64 / 108

5.12 USE OF UNDERCARRIAGE WITH RUBBER TRACKS
Avoid the following situations when operating a carriage with rubber tracks:
1. Avoid driving on hard, rocky and irregular surfaces, such as river rocks, gravel,
etc.
2.
Do not expose the rubber tracks directly to the sunlight for more than 3 months.
3. Avoid improper steering on asphalt and concrete as much as possible, since this
leads to wear of skids. In addition, avoid driving on concrete roads whose tem‐
perature is higher than 60 degrees, as it may result in wear on the tracks as well
as damage to the road surface.
4. Driving with a loose track on an irregular surface may lead to the detachment of
the skid and/or damage to the rubber track.
5. Rubber tracks are needed only for soft terrain, not hard and abrasive surfaces
such as sand, rocks, stones, etc. Using the rubber tracks on these surfaces may
lead to their premature wear and tear and deformation.
6. Avoid any contact of hard edges of concrete, etc. with the rubber tracks.
7. Fuels or synthetic oils must not come in contact with the rubber tracks. However,
if that occurs, clean the tracks immediately.
8. The use of rubber tracks on coastal marine areas should be avoided, as sea air or
salt in general corrode the adhesion between the rubber and the metal core insi‐
de.
5.13 PRELIMINARY CHECK BEFORE START THE WORK
Every day before use the dumper take the following points:
• Check there isn’t losses from the idraulic components of the machine. If there is
a losses repair or replace the component damage and adjust the oil level if it’s
necessary.
• Thoroughly clean the machine and check that there is no onset of corrosion and
that there are no cracks round‐about all welded parts.
• Check the correct track tensions and the integrity for all component of the
undercarrige.
• Verify that there isn’t component damage, broke or losses; the correct torque for
security bolts, nuts, rings. Replace, fasten and adjust following the instruction of
the manufactures before use the machine.
• Remove debris that can cause fire or breaks, take particular attention for the area
around the engine.
• Clean the control lever protection and the platform and levers from oil or debris
that can prevent the execution of the maneuvers and endanger the operator.
Check the integrity of the elettrical componets.
• Check the state of the stickers on the machine, that must to be visible.
C
OMPACT DUMPER
HS701 ‐ H
INOWA
62
MUHS70120615