ENGINE (J05E)/TROUBLESHOOTING
2–398
1.
Inspect the condition of engine speed main sensor (crankshaft
position sensor) connector (looseness or poor contact).
2.
Check the installation of the engine speed main sensor. (Crank-
shaft position sensor)
NO
YES
1.
Perform an engine warm up. (engine coolant temperature: 80
C
{176
F} or more)
2.
Stop the engine.
3.
Set the starter key to the "ON" position.
4.
Select [Engine] and check if any followings DTCs (cylinder #1:
P0263, #2: P0266, #3: P0269 and #4: P0272) have been detected.
NO
YES
12
Inspect the engine speed main sensor (Crankshaft position sensor)
Engine speed main sensor (Crankshaft position sensor)
Connector
Flywheel housing
SHTS021270300359
Was any failure found?
Repair or replace the faulty parts.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 13.
13
Check the DTC detected 5 (engine ECU)
SHTS021270300360
Have any DTCs (cylinder #1: P0263, #2: P0266, #3: P0269 and #4: P0272) been detected?
Inspect the crankshaft, connecting rods, fly-
wheel, and other parts of the drive system.
Perform "After-inspection work" of INFOR-
MATION section.
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.