Hill-Rom VersaCare P3200, Руководство по обслуживанию

Страница: 137 / 379

4.2 Caster
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.2 Caster
Tools required: T25 Torx®
1
screwdriver
Scissor jack
17 mm wrench
Removal
1. Set the brakes.
2. Raise the bed to the high position.
SHOCK HAZARD:
Unplug the bed from its power source. Failure to do so could result in
personal injury or equipment damage.
3. Unplug the bed from its power source.
4. For foot end casters, do the following:
c. Remove the screw (A) securing the foot end cover (B) to the bed (see
figure 4-3 on page 4-6).
d. Remove the foot end cover (B).
e. Using the scissor jack, raise the corner of the bed that the caster is being
removed from.
f. Loosen the nut (C) on the clamp (D).
g. Remove the brake/steer pedal (E) from the bed.
h. Remove the caster (F) from the bed.
5. For head end casters, do the following:
a. Remove the screw (G) securing the head end cover (H) to the bed.
b. Remove the head end cover (H).
c. Using the scissor jack, raise the corner of the bed that the caster is being
removed from.
d. Loosen, but do not remove, the setscrew (I) on the torque tube (J).
e. Loosen the nut (K) on the clamp (L).
f. Remove the brake/steer pedal (M) from the bed.
g. Remove the caster (N) from the bed.
1. Torx® is a registered trademark of Textron, Inc.
4
VersaCare™ Bed Service Manual (MAN333 REV 2) Page 4 - 5