IMPORTANT:
If the DIMM latches are not fully closed, the baffle will not sit properly.
9.
Install the air baffle (
on page 22).
10.
Close the front bracket.
11.
Install the access panel.
12.
Install the server into the chassis (
on page 14).
13.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber, to flashing green, and then to green.
To configure the memory mode, use UEFI System Utilities (see
Installing the cable retention clip
You can install an optional cable retention clip that attaches to the fabric management cable and then to the
mezzanine card for additional stability.
Procedure
1.
on page 16).
2.
on page 17).
3.
Place the server on a flat, level work surface.
4.
on page 18).
5.
Remove the rear support bracket (
Removing the rear support bracket
on page 22).
6.
Remove the mezzanine card.
32
Hardware options installation
Содержание HPE ProLiant XL230k Gen10
Страница 10: ...Chassis server bay numbering Chassis I O module bay numbering 10 Component identification...
Страница 43: ...4 Install the riser cover 5 Install the riser into the I O module Hardware options installation 43...
Страница 58: ...Cabling Front panel LED board assembly cabling SATA drive cabling 58 Cabling...
