Removing a hot-plug drive
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles, expansion
slot covers, or blanks installed. If the server supports hot-plug components, minimize the amount of time
the access panel is open.
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
installed on one side of the chassis must be turned 180° when they are installed on the opposite side.
1.
Determine the status of the drive from the hot-plug drive LED definitions (
Hot-plug drive LED definitions
on page 8).
2.
Back up all server data on the drive.
3.
Remove the drive.
Removing the server
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles, expansion
slot covers, or blanks installed. If the server supports hot-plug components, minimize the amount of time
the access panel is open.
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
installed on one side of the chassis must be turned 180° when they are installed on the opposite side.
Procedure
1.
Power down the server (
on page 16).
The system power LED changes from green to amber.
2.
Disconnect all peripheral cables from the front of the server.
3.
Remove the server.
Operations
17
Содержание HPE ProLiant XL230k Gen10
Страница 10: ...Chassis server bay numbering Chassis I O module bay numbering 10 Component identification...
Страница 43: ...4 Install the riser cover 5 Install the riser into the I O module Hardware options installation 43...
Страница 58: ...Cabling Front panel LED board assembly cabling SATA drive cabling 58 Cabling...
