Procedure
1.
Power down the server (
on page 16).
2.
Remove the server (
on page 17).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 18).
5.
Open the front bracket.
NOTE:
Depending on the server configuration, the HPE Smart Storage Battery or the M.2 enablement
backplane might be installed on the front bracket.
Removing a server blank
CAUTION:
To prevent improper cooling and thermal damage, do not operate the chassis unless all bays
are populated with a component or a blank.
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
installed on one side of the chassis must be turned 180° when they are installed on the opposite side.
Procedure
Remove the component as indicated.
Operations
19
Содержание HPE ProLiant XL230k Gen10
Страница 10: ...Chassis server bay numbering Chassis I O module bay numbering 10 Component identification...
Страница 43: ...4 Install the riser cover 5 Install the riser into the I O module Hardware options installation 43...
Страница 58: ...Cabling Front panel LED board assembly cabling SATA drive cabling 58 Cabling...
