Henkelman Lynx 32, Руководство пользователя, Страница: 36 / 48

36
Replacing the sealing wire
 Remove the seal bar from the machine by lifting it vertically up (1)
 Remove the Teflon tape from the seal bar (2)
 Remove the screws at the bottom of the sealing bar in order to remove the wires (3)
(4)
 Remove the Teflon tape at top of the seal bar and stick a new piece of Teflon tape of
the same length after having degreased and cleaned the bar with a dust free cloth (5)
 Cut a new piece of sealing wire or cut-off wire to the size of the sealing beam plus
about 15 cm (± 6 inches).
 First attach one side of the wire at a side of the seal bar and screw it tight.
 Now attach the other side of the wire at the other side of the seal bar. Pull the wire by
using a plier and tighten the screws at the same time (6). The sealing wires should be
tight and not protrude the plastic end blocks.
 Cut the wire ends on both sides.
 Cut a piece of Teflon tape as long as the seal bar plus about 5 cm (± 2 inches).
 Ensure that the Teflon is stuck to the bar smoothly and without folds.
 Cut the Teflon tape off such that the sticky part does not get stuck on the sides, but
only covers the top of the clamps (2).