Helmer iBX020, Руководство по техническому обслуживанию

Страница: 24 / 55

360203-1/B
23
Maintenance & Service
9 .5 Inspect and Secure Electrical Wiring and Terminals
Disconnect HaemoBank™ from AC power when inspecting and securing wiring terminals.
NOTE
Accessing rear and/or side panels for servicing may require moving the unit. Take care when moving units equipped with leveling
legs as they may cause damage to the floor.
Required tools:
► #2 Phillips screwdriver
Inspect components and secure terminals:
1
Switch the i.C3 Monitoring System / Access Control ON/OFF switch
OFF
. Switch the AC ON/OFF switch
OFF
. Disconnect the AC power cord from the power receptacle.
2
Locate the cover to the electrical panel on the lower left side of the unit.
3
Using a #2 Phillips screwdriver, loosen the 2 screws in the top corners of the cover and remove the remaining
6 screws securing the cover to the unit.
3
Slide the cover upward to disengage the 2 screws from the keyhole openings, remove and set aside.
4
Using a #2 Phillips screwdriver, remove the 3 screws securing the electrical panel and rotate the panel
outward.
5
Visually inspect the wiring in the electrical box for discoloration.
► If any discoloration is found, contact Haemonetics® Corporation BloodTrack® Customer Support
Electrical panel
6
Gently pull on all wires which are terminated with a connector.
► If any wires are loose in the terminal connector, replace the connector.
► If any terminal connectors are loose in the terminal strip, reseat them.
7
Rotate the electrical panel inward and secure with 3 screws using a #2 Phillips screwdriver.
8
Replace the cover over the electrical panel and secure with screws using a #2 Phillips screwdriver.
9
Reconnect AC power cord to the power receptacle. Switch the AC ON/OFF switch
ON
. Switch the i.C
3
Monitoring System / Access Control ON/OFF switch
ON
.