41
GABLE UNITS
PARTS REQUIRED:
3" (7,6 cm)
x32
x2
Gable Units
Measure 1-1/2" down from top plate and mark at each side as shown.
Set gable unit on wall doubler.
Hold gable unit secure with (1) 2" nail at each side as shown.
1
BEGIN
BE SURE GABLE IS CENTERED ON WALL BEFORE NAILING.
2
Continue nailing lower edge of panels into wall doubler. Secure with 2" nails spaced 6" apart, as shown
Your gable units are now installed.
FINISH
2" (5,1 cm)
x46
3"
(7,6 cm)
Screws
NAIL FIRST
2" (5,1 cm)
NAIL FIRST
2" (5,1 cm)
6"
(15,2 cm)
Fig. A
WALL DOUBLER
1-1/2"
(3,8 cm )
Measure and
Mark
1-1/2"
(3,8 cm )
Measure and
Mark
Working inside, secure gable unit with 3" screws into
UV
and doubler at an angle, as shown
(Fig. B)
.
Secure gable unit framing to end
rafter with 3" screws, as shown
(Fig. C)
.
3
4
Repeat steps to install opposite side gable unit.
Fig. C
UV
3" (7,6 cm)
Screws
Fig. B
UV
