13
BEGIN
¸
1
PARTS REQUIRED:
x 144
2" (5,1 cm)
RAFTER ASSEMBLY
x12
6 x 24" (15,2 x 61 cm)
OSB OR WOOD GRAIN
1/4" (1,9 cm)
GAP
1/4" (1,9 cm)
GAP
ECN x2
Fig. A
Keep rafters firmly against
AL
at both ends when securing gusset.
You have finished assembling your rafters.
Remove jig parts
AL
from floor.
Flip rafters over and fasten a second gusset with (12) 2" nails. No need to use jig for the 2nd gusset.
3
4
2
Place gusset on
ECN
, holding a 1/4" gap from edge
(Fig. B)
and keeping rafters firm, as instructed.
Secure the gusset to the rafters with (12) 2" nails in the pattern shown
(Fig. B)
.
Place (2) rafters
ECN
in the jig, as shown. Hold
ECN
firm against outside
AL
's as shown
(Fig.A)
and push rafters tight to the middle
AL
. Rafters should touch at tips
(Fig. B)
.
FINISH
Place two rafter-halves
ECN
in the jig, as shown (STEP - 1).
Flush rafters at peak. Secure gusset to rafters with 2" nails following the pattern shown
(FIg. B)
.
120-3/4"
(304,8 cm)
120-3/4"
(304,8 cm)
x14
2 x 4 x 75-1/4" (5,1 x 10,2 x 191,1 cm)
ECN
Build (2) rafter assemblies with (1) gusset (Fig. C).
Build 5 rafter assemblies with (2) gussets (Fig. D).
SET ASIDE THESE TWO RAFTER ASSEMBLIES.
Fig. C -
Build 2
Fig. D -
Build 5
Fig. B
1/4"
(1,9 cm)
1/4"
(1,9 cm)
Flush
