
EN
DE
33
4. ERSATZTEILE
4. SPARE PARTS
3.6. Electric heater insulation resistance
When performing the final inspection of the electrical
installations, a “leakage” may be detected when
measuring the heater’s insulation resistance. The
reason for this is that the insulating material of the
heating resistors has absorbed moisture from the
air (storage transport). After operating the heater
for a few times, the moisture will be removed from
the resistors.
Do not connect the power feed for the heater
through the RCD (residual current device)!
3.6. Isolationswiderstand des Elektrosaunaofens
Bei der Endkontrolle der Elektroinstallationen kann bei
der Messung des Isolationswiderstandes ein “Leck”
auftreten, was darauf zurückzuführen ist, daß Feuch-
tigkeit aus der Luft in das Isolationsmaterial der
Heizwiderstände eingetreten ist (bei Lagerung und
Transport). Die Feuchtigkeit entweicht aus den Wi-
derständen nach zwei Erwärmungen.
Schalten Sie den Netzstrom des Elektrosaunaofens
nicht über den Fehlerstromschutzschalter ein!
1.
Heating element 1500 W/230 V
Heizelement 1500 W/230 V
ZSK-690
2.
Heating element 2000 W/230 V
Heizelement 2000 W/230 V
ZSK-700
3.
Heating element 2670 W/230 V
Heizelement 2670 W/230 V
ZSK-710
4.
Air flow spoiler
Luftleit führung
ZSM-40
5.
Thermostat/Overheating limiter
Thermostat/Überhitzungsschutz
WX247
6.
Control panel
Bedienfeld
ZSME-200-1
7.
Power unit
Leistungseinheit
WX644
8.
ON/OFF electric switch
EIN/AUS-Schalter
ZSK-684
9.
Wall installation flange
Montagemanschette
ZSME-80
10. Data cable, 3 m
Data cable, 5 m (optional)
Data cable, 10 m (optional)
Datenkabel, 3 m
Datenkabel, 5 m (wahlweise)
Datenkabel, 10 m (wahlweise)
WX250
WX251
WX252
We recommend to use only the manufacturer’s spare parts.
Es dürfen ausschließlich die Ersatzteile des Herstellers verwendet werden.