Harman PC45, Инструкция по установке и эксплуатации

Страница: 29 / 42

29 PC 45 Corn/Pellet Stove
Options
The hopper extension allows you to put more fuel
in the hopper which extends burn time on one load
of fuel. The hopper extension adds 65 pounds to the
existing hopper capacity. The hopper extension secures
to the hopper with three latches. There may be some
knockouts to remove prior to installation. See Fig. 44.
T
he room sensor is a small temperature sensor on the
end of a 60" wire. This sensor is installed much like a
standard wall thermostat. Because it is so small, it can
be hidden along the trim of a doorway or even up the
leg of a coffee table. There is a remote room sensor port
on the rear of the unit for easy external connection. Use
standard 18-2 thermostat wire to extend the distance to
the desired location (100' maximum). The room sensor
should be installed in the location where you want to
control the temperature.
NOTE: Distances of more than 25 feet from the unit
or in another room are not recommended.
It is recommended that the room sensor be
installed, even if only installed on the rear of the unit
as a return air sensor.
room Sensor Installation
Fig. 43
Fig. 42
There is a 3-piece log set available Item # 3-40-
5647. Log bracket # 1-00-724122 is also needed for
installation of the log set. In place of the firebricks,
the log brackets attach to the brick channel. The logs
stack from largest to smallest onto the brick channel
and bracket set.
Log Brackets Installed
Fig. 44
On the rear of the stove hopper there is a
hole to fasten the hopper extension into place.
On some units, this hole will need to be
opened. You will notice a small uncut area on
rear of the knockout. Push downward with a
screwdriver or like tool until the knockout is
rotated as far back to the inside of the hopper
as possible. This will allow the swell latch of the
hopper extension to fully expand to the bottom
side of the hole for a proper seal.
Side heat shields are available to reduce the
clearance to combustible materials. See Fig. 43.
Side heat Shields
hopper Extension
Ceramic log Set