Harman PC45, Инструкция по установке и эксплуатации

Страница: 13 / 42

13 PC 45 Corn/Pellet Stove
grain Cap Installation
The grain cap is designed to enhance the burn quality
of the fuel being burned (i.e. field corn, wheat, barley,
rye, oats, etc.) Its purpose is to reflect more heat into
the burn pot. This promotes a more thorough burning
of the fuel and less ash. Depending on the quality of
the fuel being burned, the effectiveness of the grain
cap may vary.
The grain cap will need to be removed for cleaning. This
part is classified as a consumable item and is excluded
from the product warranty.
Installation:
1. Hook the slot on the grain cap over the lip on the side
rail of the burnpot, as shown.
2. Allow the grain cap to rest onto the burnpot sides.
Grain Cap
Burn Pot
Fig. 18
burn Pot with Smaller holes
The PC45 stove is built with a burn pot that has
.125 (1/8") combustion air holes. This grate has no
identifying marks.
Included with your stove is an additional grate that has
.0625 (1/16") combustion air holes. This grate can be
identified with etchings on the bottom side. An ‘S’ is
etched on one end and ‘724208’ is etched at the other
end.
Depending on the type and the moisture content, some
corn or grain will burn better with the smaller holes for
combustion air, while others may work better with the
larger holes.
To change the burn pot grate, first remove the end gate
retainer, the nthe end gate. Pull the auger extension
from the auger, and lift the grate out of the frame. Place
the new grate, install the auger extension, replace the
end gate and retainer clip. Refer to the diagrams on the
next page for guidance.
The PC45 is built with this burn
pot that has larger holes, Part #1-
10-724108.
Letter “S”
You may opt to change the
burn pot to this version with
smaller holes. This option has
the letter "S" marked on it & is
Part # 1-10-724208.