1
P e l l e t s o r C o r n /P e l l e t M i xt u r e O n l y
P3 5 i F ireplace Insert
S a ve T h e se I n st r u ct i o n s
3-90-775R16_08/13
Warning! risK of fire!
Keep combustible
materials, gasoline and other flammable vapors and
liquids clear of the appliance.
•
Do
NOT
store flammable materials in the vicinity of
the appliance.
•
Do
NOT
use gasoline, lantern fuel, kerosene,
charcoal lighter fluid or similar liquids to start or
"freshen up" a fire in this appliance.
Keep all such liquids well away from the heater while it
is in use, as combustible materials may ignite.
Warning! risK of fire!
Do
NOT
store fuel:
• Within the required clearance areas of the
appliance.
• Within the space required for fueling or ash
removal.
5 . Cleaning Area Beneath Burn Pot G rate
F req uency:
onthly or more frequently depending
on fuel quality and or ash buildup.
By:
User
loosen the two wingscrews
on the front of the burn pot.
lift the cover off of the
wingscrews.
5 . Cleaning Heat Ex changer & Ex haust
F req uency:
onthly or after each ton of fuel is
burned.
By:
User
It is recommended that you use a vacuum that is
designed for ash, as ashes may block conventional
vacuum filters.
NOTICE: or optimal performance of your pellet
burning appliance, you must perform regular cleaning
and maintenance as directed in this manual. Not doing
so will result in:
Poor performance
Smoke spillage into the room
Overheating of components
ailure to perform regular cleaning on your pellet
burning appliance will void the warranty.
a. ake sure the fire is out and cool. isconnect power
cord prior to servicing.
b. Scrape the ma ority of ashes into the ash pan. Begin
with the back and roof above the burn pot.
c. Scrape the ashes from both sides, into the ash pan.
a. Loosen the two wingscrews located on the front of
the burn pot housing.
b. Lift the cover off of the wingscrews and set aside.
c. Using your ash-vac, remove any ashes or debris
from the air chamber.
d. You can tap on the igniter, located above the cleanout
hole. This will help to remove any accumulation on
the igniter element.
e. Re-install the cleanout cover and tighten the
wingscrews. Be sure that the cover is completely
covering the hole, as air leakage here may lead to
incomplete combustion or poor ignition.
