P3 5 i F ireplace Insert
P e l l e t s o r C o r n /P e l l e t M i xt u r e O n l y
S a ve T h e se I n st r u ct i o n s
- 0-775R1 08 1
4 . Distribution Blower
Requires no lubrication.
eep the motor windings and squirrel cage fan free of
dust. Can be wiped clean or vacuumed.
To remove distribution blower
• Slide the insert body out of the mounting frame.
• Locate the blower in the back of the unit. You ll
need to tilt the unit forward for easy access.
• Remove 8 tek screws using a 5 1 driver or
wrench.
8 screws
5 . F eeder Body
Wipe or vacuum to clean.
Use a vacuum to remove fines and sawdust.
To access feeder cleanout
• Slide the insert body out of the mounting frame.
• Locate the feeder cover from the right side of the
unit.
• Loosen the wing nut approximately
of the way
out on the stud.
• Pull out on the bottom of the cover then lift upward
to remove.
• Notice the deflector shield is sitting loose in the
feeder. It can be removed by rolling it from under
the pusher arm shaft. ust be sure it is repositioned
properly.
• When re-installing cover, tighten the wing nut hand
tight only.
Loosen wing nut to remove cover
acuum fine r m t
area
