17
P e l l e t s o r C o r n /P e l l e t M i xt u r e O n l y
P3 5 i F ireplace Insert
S a ve T h e se I n st r u ct i o n s
3-90-775R16_08/13
6
Mobile Home
A. Mobile Home Installation
Outside Air K it
# 1 -0 0 -7 7 4 2 8 0
Must be used
for installation in a mobile home.
1. An outside air inlet must be provided for
combustion air, and must remain clear of leaves,
debris, ice, and or snow. The outside air path must
be unrestricted while the appliance is in operation.
2. The combustion air intake system must be of
metal construction. It must permit zero-clearance
to combustible materials, and contain a rodent
screen.
. The appliance must be secured to the mobile
home structure by bolting it to the floor. Use the
correct length lag-bolts through the same holes
that secured the appliance to the shipping pallet.
. The appliance must be grounded to the metal
framing of the mobile home.
5. All clearances to combustibles and floor protection
requirements must be followed.
. ollow the vent manufacturer s instructions
when installing in a mobile home. Use silicone
or equivalent to create an effective vapor barrier
where the chimney or other component penetrates
to the exterior of the mobile home.
7. Installation shall be in accordance with the
anufactured Home and Safety Standard (HU )
C R 280, Part 2
8. The appliance must never be installed in a room
designated for sleeping.
. The space heater must be connected to a factory
built chimney conforming to CAN ULC-S 2 .
aximum 8 inch diameter. Chimney must be
removable to allow transport of mobile home.
Installation must comply with anufactured Home and
Safety Standard (HU ), C R 280, Part 2 .
CAUTION
Maintain structural integrity of mobile home:
F loor, wall, ceiling and/ or roof.
o
NOT
cut through:
•
loor oist, wall studs, or ceiling trusses.
• Any supporting material that would affect the
structural integrity.
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity.
• Enclosed space such as an attic or garage
There are a few holes in the bottom of the insert
mounting frame which can be used for lag bolts. Use
at least two of these holes for securing the appliance
to the fireplace floor in a mobile home installation. The
installer will need to determine and obtain the properly
sized lag bolts and masonry anchors.
Four 5/16 -18 L
eveling
bolts ma
y b
e installed
in each c
orner
Numer
ous holes allo
w
for lag b
olts (2 min.)in
mobile home installa
tion
Never install in a room intended for sleeping.
W AR NING
W AR NING
