Hamilton Beach SmartServe BIC2000, Руководство по обслуживанию

Страница: 34 / 92

Page 34 of 92
520008300 08/14
SmartServe™ Drink Mixers Service Manual
Removal and Replacement
Touch Pad
The touch pad is located on the operator interface panel and is used by the operator to control
the machine.
To remove the touch pad:
1. Remove the operator interface panel assembly (1) as outlined in this manual.
2. Disconnect the touch pad ribbon cable (2) from the display board (3).
3. Using a flat tool, such as a razor, start at the corner and peel the touch pad (4) off the
operator interface panel assembly (1).
4. Pull the ribbon cable (2) through the slot on the operator interface panel assembly (1).
1
4
2 3
To install the touch pad:
1. Clean the surface thoroughly to remove any adhesive residue.
2. Clean the LCD screen to remove any smudges or fingerprints.
3. Insert the ribbon cable (2) through the slot of the operator interface panel assembly (1).
NOTE:
The adhesive on the touch pad will adhere to the plastic instantly. It will be very difficult
to reposition the touch pad if not aligned properly. Be careful to avoid air pockets/bubbles. Do
not remove the protective paper all at once.
4. Apply the touch pad (4) starting on the upper left side and slowly roll the protective
paper off the touch pad (4) while applying the touch pad (4) to the panel. Continuously
feed the ribbon cable (2) through the slot.
5. Connect the touch pad ribbon cable (2) to the display board (3).
6. Install the operator interface panel assembly (1) as outlined in this manual and verify
operation.