– 62 –
5. Slide the motor toward the rear of the washer
and set it on the washer base.
6. Push forward on the tub assembly and rotate
the motor shaft upwards to remove the motor
from the rear of the washer.
Operation of the motor assembly can be checked
by using Service Mode tests 15 and 26 (see
the
Service Mode Test
in the
Diagnostics
and
Service Information
section of this guide).
Specific failures associated with the motor
assembly can initiate Fault Code 3 (see
Fault
Codes
section in this service guide).
NOTE
: When reinstalling the motor belt, insure it
is positioned using the outer most motor pulley as
shown.
Also, to make it easier to reinstall the drive belt,
a wire tie can be used to hold the belt onto the
pulley as it is rotated.