Haas Mill, Руководство оператора

Страница: 73 / 217

Operation 66 96-8000 rev R June 2007
STOP PLAY RECORDER DELETE ALL DELETE ONE
SKIP START SKIP END BACK ONE FORWARD ONE
1-DRILL
2-TAP
3-FEED
These commands are:
Stop – Stops the recording.
Play – Starts the playback, starting with the highlighted process. The mill will not start until Cycle Start is
pressed.
Record – Begins recording the functions and entered data.
Delete All – Deletes all the recorded processes.
Delete One – Delete a single queued process. Note that it will only delete the last process within the play
list. If a process is not last, you will have to delete all the processes that occur after it until you get to the one you
need. Pressing the “Delete” key will delete the last process too.
Skip Start – Rewinds program to the first process. Pressing “Home” will return to the first process in the list as
well.
Skip End – Forwards the program to the last process. Pressing “End” will skip to the end of the processes list as
well.
Back One – Steps backwards through the processes. Pressing the up arrow on the keypad will do the same.
Forward One – Steps forwards through the processes. Pressing the down arrow on the keypad will do the same.
Operation
Enter the IPS feature, by pressing “Handle Jog”. Use the left and right arrow keys to highlight the “System” tab and
Press “Enter”. Use the left and right arrow keys to highlight the “Recorder” tab and press “Enter”.
Additionally, the Recorder mode can be entered quickly by pressing F4 from any IPS screen. F4 will toggle the
Recorder mode on and off.
Creating a Part Program
To develop a part program, set the Recorder/Player to “Record”, exit the System mode and enter the mode for the
first process. Notice that when the control is in “Record” mode a blinking red “Recording” will display in the upper
left.
Set up the machining process, enter the values and press “Cycle Start”. The mill will run the program and cut the
first feature. Once finished, repeat the previous steps for the remaining part features. Note: Once Cycle Start is
pushed, the operation is recorded, even if the operation is not completed.
Once all the machining processes are entered, return to the Recorder/Player (or press F4 to bring up the Re-
corder), highlight “Stop” and press “Enter” (or press F4), this stops the recording session.
You will notice that there is now a list of processes in the recorder window. These can be edited from this page
using the other Recorder/Player buttons. An alternative for editing the operations is to execute the operation, then
enter MDI mode. MDI mode reveals the machine code and can be edited there.
Note: If the machine is equipped with a tool changer the mill will automatically
change tools as needed in the program.