Haas Bar Feeder, Руководство по установке

Страница: 3 / 13

1
Press [POWER OFF] on the lathe.
Set the main circuit breaker to the OFF position.
Lock the main circuit breaker. Use an approved
lock with an approved safety tag.
If the lathe is an ST-35, or if the machine was
made before 11/1/2015, install the coolant
collector extension [1] onto the lathe.
Attach the spindle liner adapter [2] to the spindle.
Refer to LATHE - EXTRUDED SPINDLE LINER -
ADAPTOR KIT - INSTALLATION . If the lathe is an
ST-35, refer to LATHE - ST-30/30Y BIG BORE,
ST-35/35Y - SPINDLE LINER KIT - INSTALLATION .
2
Put the bar feeder adjacent to the lathe.
Make sure the frame ends [1] are parallel to the
front [2] of the lathe.
Remove the shipping brackets [3] from the frame
of the bar feeder.
3
Pull the bar feeder [1] forward until it locks into
position.
Find the end of the bar feeder [2].
If the lathe is an ST-35, find the end of the
coolant-collector extension [3].
If the lathe is an ST-10, ST-15, ST-20, ST-25, ST-30,
or DS-30, find the edge of the coolant collector.
Make sure that the space [4] between them is
approximately 0.50" (13 mm).
4
Find the (4) height adjustment screws [1].
Turn the screws [3] until the frame is 2.0" (51
mm) [2] above the floor [4].
Haas Bar Feeder - Installation - NGC - AD0406
Page 3 of 13 pages