Haas Bar Feeder, Руководство по установке

Страница: 11 / 13

6
Make sure the enclosure [1] is level to the
ground.
Tighten the (8) cart screws [2].
Remove the adjustment tool.
Replace the racks for the spindle liners.
Find the (4) height adjustment screws [3].
7
Look at where the push rod [2] goes into the
spindle adapter [1].
Turn the (4) height adjustment screws until the
center of the push rod aligns with the center of
the adapter.
Look at where the push rod [4] goes out of the
spindle [3].
Turn the (4) height adjustment screws until the
center of the push rod aligns with the center of
the spindle.

Note: Gravity pulls the end of the push rod
down a small distance.
Tap the frame ends with a rubber mallet to move
the bar feeder from side-to-side, if necessary.
Return the push rod to its home position.
8
Step on the release pedal.
Push the bar feeder backward to the end of its
travel.
If the bar feeder is correctly leveled, the gas
shock holds the bar feeder in the rear location.
If the bar feeder must be aligned, adjust the rear
feet until the bar feeder smoothly locks in the
forward position and moves fully backward.
Haas Bar Feeder - Installation - NGC - AD0406
Page 11 of 13 pages