Haas Bar Feeder, Руководство по установке

Страница: 10 / 13

3
Press [EMERGENCY STOP] .
Install the 0.75" push rod [2] on the push rod
assembly [1].
Refer to the operator's manual for instructions to
install the push rod.
Turn the adjustment wheel [3] for the transfer
table until the table is at the bottom.
4
Remove the left-hand rack for the spindle liners.
Remove the sticker [3] from the socket hole [4] on
the bar feeder.
Put the sticker above the socket hole.
Find the (8) cart screws [5].
Each side of the bar feeder has (4) screws.
Loosen the (8) screws.
Put the adjustment tool [2] into the socket.
5
Release the [EMERGENCY STOP] .
Press [RESET] to stop each alarm.
Press [RECOVER] to enter the bar feeder recovery
mode:
Press [F2] to load the push rod.
The pusher clears the tray then the push rod
assembly moves down.
Press [EMERGENCY STOP] .
Use your hand to move the push rod actuator [1]
toward the lathe.
Use the adjustment tool [3] to move the bar
feeder [2] up or down until the push rod can go
into the liner adaptor.
Haas Bar Feeder - Installation - NGC - AD0406
Page 10 of 13 pages