Haas Bar Feeder, Руководство по установке

Страница: 12 / 13

Haas Bar Feeder - Anchor Instructions
1
Turn the rear feet [1] until they are parallel to the
bottom rails, as shown.
The front feet [2] must remain perpendicular to
the bottom rails, as shown.
2
Use a pen [1] to put a mark on the floor at the
location of each foot.

Note: Turn the feet to the sides of the bar
feeder to avoid a tripping hazard.
Drill [2] a Ø 0.50" (13 mm) hole in each mark.
Drill the hole to a depth of 2.0" (51 mm).
3
Put the foot [3] over the hole [4].
Put an anchor [2] into the hole.
Use a hammer [1] to tap the anchor.
Tap the anchor until it is at the bottom of the
hole.
Put a washer [6] and a nut [5] on the bolt.
Torque each nut to 55 ft-lb (75 Nm).
Haas Bar Feeder - Installation - NGC - AD0406
Page 12 of 13 pages