Haas Bar Feeder, Руководство по установке

Страница: 5 / 13

1
Find the access door [2] at the bottom of the
control cabinet [1].
Open the access door.
Install the conduit bracket [3] to the bottom of
the control cabinet.
Use (2) screws to attach the bracket.
2
Find the cable conduit [2] under the bar feeder.
Put the cable conduit through the hole [1] in the
side of the lathe enclosure.

Note: Some lathes do not have the hole. If the
lathe does not have a hole, make one with a 2.0"
(51 mm) hole saw. No hole is necessary for the
ST-10.
Put the conduit through the conduit bracket [3].
Push the conduit [5] up through the cable exit [4]
in the bottom of the control cabinet.
3
Open the control cabinet.

Danger: If the voltage indicator light is on, do
not touch the electrical components. The high
voltage in the control cabinet can kill you. Wait for
the voltage indicator LED to go off fully.
Find the location on the amplifier bank that has
the "BAR FEEDER /W AXIS" label [1].
Install the 30-Amp servo amplifier [2], included
with the bar feeder, into that location.
Haas Bar Feeder - Installation - NGC - AD0406
Page 5 of 13 pages