H3C UniServer R4900 G3, Руководство пользователя

Страница: 74 / 299

65
c.
Install the M.2 transfer module. The installation procedure is the same for an M.2 transfer
module and a SATA optical drive. For more information, see "
Installing a SATA optical
drive ."
d.
Connect the SATA M.2 SSD cable to the system board. For more information, see
"
Connecting the SATA M.2 SSD cable ."
11.
(Optional.) Install the removed security bezel. For more information, see " Installing the security
bezel ."
12.
Install the removed fan cage. For more information, see " Installing fans ."
13.
Install the removed chassis air baffle. For more information, see " Installing air baffles ."
14.
Install the access panel. For more information, see " Replacing the access panel ."
15.
Rack-mount the server. For more information, see " Rack-mounting the server ."
16.
Connect the power cord. For more information, see " Connecting the power cord ."
17.
Power on the server. For more information, see " Powering on the server ."
Installing SATA M.2 SSDs at the server rear
Guidelines
You can install a maximum of two SATA M.2 SSDs on an M.2 SSD expender module. The installation
procedure for the two SSDs is the same. In this example, two SATA M.2 SSDs are installed.
Procedure
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Replacing the access panel ."
4.
Install the SATA M.2 SSD to the M.2 transfer module:
a.
Insert the connector of the SSD into the socket, and push down the other end of the SSD.
Then, fasten the screw supplied with the transfer module to secure the SSD into place, as
shown in
Figure 80 .
CAUTION:
To install only one SATA M.2 SSD, install it in the socket marked with J4.
b.
Connect the SATA M.2 SSD cable to the M.2 transfer module, as shown in Figure 80 .