H3C UniServer R4900 G3, Руководство пользователя

Страница: 53 / 299

44
Installing an RC-GPU/FHHL-2U-G3-2 or
RC-2GPU-R4900-G3 riser card and a PCIe module
The installation procedure is the same for the RC-GPU/FHHL-2U-G3-2 and RC-2GPU-R4900-G3.
This section installs the RC-GPU/FHHL-2U-G3-2.
To install an RC-GPU/FHHL-2U-G3-2:
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Replacing the access panel ."
4.
Remove the PCIe riser card blank from PCIe riser connector 3, as shown in Figure 42 .
5.
Install the PCIe module to the riser card:
a.
Remove the screw on the PCIe module blank in the target PCIe slot, and then pull the blank
out of the slot, as shown in
Figure 52 .
Figure 52 Removing the PCIe module blank
b.
Insert the PCIe module into the slot along the guide rails and use the screw to secure it into
place, as shown in
Figure 53 .
Figure 53 Installing the PCIe module
6.
Install the riser card bracket and use its screws to secure it into place, as shown in Figure 45 .
7.
Insert the riser card in PCIe riser connector 3 and fasten the captive screw to the chassis air
baffle, as shown in
Figure 54 .