H3C S5130-30C-HI, Руководство по установке

Страница: 39 / 89

32
This section uses the LSWM2SP2PM card (with an ejector lever) and the LSPM6FWD card (without
an ejector lever) as examples to describe the procedures for installing and removing an expansion
card.
Installing an expansion card
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Use a Phillips screwdriver to remove the mounting screw on the filler panel over the expansion
card slot. Then remove the filler panel. See
Figure 45 .
Keep the removed filler panel for future use.
Figure 45 Removing the filler panel over an expansion card slot
3.
Unpack the expansion card.
4.
Perform the following steps to install the expansion card:
a.
Rotate rightward the ejector lever on the expansion card. Skip this step if the expansion
card does not have an ejector lever.
b.
Gently push the expansion card into the slot along the guide rails until the expansion card
has good contact with the chassis.
The LSPM6FWD firewall card adds 75 mm (2.95 in) to the depth of the switch, as shown
in
Figure 48 .
c.
Rotate leftward the ejector lever. Skip this step if the expansion card does not have an
ejector lever.
d.
Use a Phillips screwdriver to fasten the captive screw on the front panel to secure the
expansion card in the slot.