H3C S5130-30C-HI, Руководство по установке

Страница: 30 / 89

23
To install a power module:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel from the target power module slot as follows:
a.
Remove the screws on the filler panel.
b.
Use a flathead screwdriver to remove the filler panel.
Figure 31 Removing the filler panel
3.
Unpack the power module and verify that the power module model is correct.
4.
Correctly orient the power module with the power module slot (use the letters on the power
module faceplate for orientation), grasp the handle of the power module with one hand and
support its bottom with the other, and slide the power module slowly along the guide rails into
the slot (see callout 1 in
Figure 32 ).
5.
Fasten the captive screws on the power module with a Phillips screwdriver to secure the power
module in the chassis (see callout 2 in
Figure 32 ). If the captive screw cannot be tightly fastened,
verify the installation of the power module.
6.
Install the filler panel over the empty power module slot to prevent dust and ensure good
ventilation if you install only one power module.
Figure 32 Installing a PSR150-A1 power module
Removing a PSR150 power module
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.