Operation Manual – Port Correlation Configuration
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
1-5
1.1.5 Configuring a Port Group
To make the configuration task easier for users, certain devices allow users to configure
on a single port as well as on multiple ports in a port group. In port group view, the user
only needs to input the configuration command once on one port and that configuration
will apply to all ports in the port group. This effectively reduces redundant
configurations.
A Port group belongs to one of the following two categories:
z
Manual port group: manually created by users. Multiple Ethernet ports can be
added to the same port group;
z
Dynamic port group: dynamically created by system, currently mainly applied in
link aggregation port groups. A link aggregation port group is automatically
created together with the creation of a link aggregation group and cannot be
created by users through command line input. Adding or deleting of ports in a link
aggregation port group can only be achieved through operations on the link
aggregation group.
Follow these steps to enter port group view:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter manual port group
view
port-group manual
port-group-name
—
Enter port
group
view
Enter aggregation port
group view
port-group
aggregation
agg-id
—
Follow these steps to configure a manual port group:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Create a manual port
group
port-group manual
port-group-name
Required
This operation also leads
you to manual port group
view.
Add Ethernet ports to the
manual port group
group-member
interface-list
Required
Note:
For information about link aggregation port group, refer to
Link Aggregation
Configuration
.