Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 NQA Configuration
1-30
1.3.3 Configuring Trap Delivery
I. Configuration prerequisites
Before configuring Trap delivery, you should configure the address of the network
management server which receives the Trap message. For detailed configuration
procedure, refer to the
SNMP-RMON Configuration
part of the manual.
II. Configuring Trap delivery
A trap message is generated no matter whether an NQA test succeeds or fails. You can
set a switch to control the delivery of the trap message to the network management
server.
Follow these steps to configure Trap:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create an NQA test group
and enter its view
nqa
admin-name
operation-tag
Required
Enable trap debugging to
send a trap message to
the network management
server
send-trap
{
all
|
{
probefailure
|
testcomplete
|
testfailure
}* }
Optional
No trap message is sent
to the network
management server by
default.
Configure the minimum
number of probe failures
in an NQA test before a
test failure trap message
is sent
test-failtimes
times
Optional
1 by default.
Configure the number of
consecutive probe failures
in an NQA test before a
trap message is sent to
indicate a probe failure
probe-failtimes
times
Optional
1 by default.
Note:
Currently, the device does not support Trap message delivery. Therefore, the above
configuration does not take effect actually.