H3C CR16000-M, Руководство по установке

Страница: 31 / 116

3-2
Table3-1 Slide rails available for the router
Router
model
Chassis
weight (fully
configured)
Available slide rails
Slide rail
model
Max.
load-bearing
capacity
Adjustment range
Occupied
rack
space
CR16000
-M8
66 kg (145.50 lb)
RL-1U-A 200 kg (440.92 lb)
380 to 630 mm (14.96
to 24.80 in)
1 RU
CR16000
-M16
81 kg (178.57 lb)
Installing cage nuts
Before mounting the chassis in the rack, attach cage nuts to the front rack posts.
1. Determine the installation holes for cage nuts based on the mounting holes in the mounting
brackets and the installation position of the slide rails.
You can use a reference (such as a tape measure) to record the installation holes of the
mounting brackets and mark the cage nut holes on the rack posts accordingly.
2. Install cage nuts into the marked square holes on the front rack posts.
Figure3-1 Installing cage nuts
Mounting the router in the rack
WARNING!
•
Do not hold the handle of a fan tray or power supply, air vents, or the handle on the real panel to
move the router. Doing so might cause equipment damage or even bodily injury.
•
The router is heavy. As a best practice, use a mechanical lift to move it.
•
After placing the router on the slide rails, do not leave go of your hands immediately because this
might tip the router, damaging the router or even causing bodily injury.
To mount the router in the rack:
1. Orient the chassis with its rear facing the front of the rack.
2. Use a minimum of four people to lift the router by using the handles or supporting the bottom of
the chassis until the bottom of the router is a little higher than the slide rails on the rack.
3. Place the router on the slide rails and slide the router along the slide rails until the mounting
brackets on the router are flush against the front rack posts.