H3C CR16000-M, Руководство по установке

Страница: 24 / 116

2-6
•
Keep the device and its original packaging (including fillers and plastic bags) secure, and seal
and archive the unpacking inspection records, photos of damaged goods, and photos of
packaging and all label information on the packaging.
•
The engineer on site fills in the cargo issue table within one working day and reports it to the
H3C supply chain contact.
Unpacking and inspecting the chassis
1. Place the carton flat on the ground.
2. Use a utility knife to cut the straps on the carton. Open the carton and take the top foam cushion
out of the carton.
Figure2-3 Opening the carton
3. Take the chassis and its accessory boxes out from the carton and keep them secure.
4. Verify that the chassis is intact without any signs of water soaking or corrosion and the labels on
the chassis are correct, clear, and complete.
5. Verify that the accessory box packaging is intact and not damaged. Check the accessories
against the packing list to ensure that you have received all accessories.
Unpacking and inspecting removable components
CAUTION:
•
To avoid ESD damages to electronic components, wear ESD gloves or an ESD wrist strap when
handling a module and prevent any body contact with the electronic components.
•
After you take a module from a low temperature and dry place to a high temperature and wet
place, wait 30 minutes before unpacking the carton to prevent card damage caused by moisture
condensation.
IMPORTANT:
Check the components against the packing list and make sure you have received all components as
ordered.
Typically, the removable components for the device such as modules and power supplies are packed
and shipped in cartons. The packaging for the components includes cartons, shockproof foam, and
anti-static bags.
To unpack and inspect a removable component: